A paint sprayer hires for roughly $60 to $100 a day and $180 to $280 for the week, and almost all of them at a rental counter are airless. The rate is the easy part. Tips are usually sold rather than lent, and the cleaning charge for a rig returned with dried coating in it can exceed the hire.
Airless, HVLP or texture
Airless pumps push unthinned paint through a small tip at high pressure and are the workhorse for walls, fences and exteriors. HVLP atomises gently at low pressure for cabinets and trim where finish quality matters more than speed. Texture rigs and hoppers handle drywall mud and stucco and are hired as their own class.
The tip decides the finish
Tip size sets both fan width and how much material passes. Thin stains and lacquers want a small orifice, wall paint a medium one, and elastomeric or block filler a large one. Rental yards normally sell the tip rather than include it, so name your coating when you book and buy the right one at the counter.
Hose length, and what it costs you
Long hose runs let you leave the pump on the ground rather than dragging it, at the cost of pressure at the gun. Most counters carry fifty-foot sections and will add more for a fee. If you are spraying a two-storey exterior, ask for the extra length up front rather than moving the pump every wall.
Cleaning is a contract line, not a courtesy
Every rental agreement for a sprayer expects it back flushed. Dried latex in a pump or a filter means a cleaning charge, and where the pump is damaged you are paying for repair rather than a fee. Flush with the correct solvent for the coating, pull and clean the filters, and leave storage fluid in it.
Questions people ask about paint sprayer rental
What tip size do I need for wall paint?
Interior latex on walls is typically sprayed through a mid-range tip that gives a fan around ten to twelve inches. Bring the paint's data sheet or the can to the counter, because manufacturers publish a recommended tip range for each product.
Is paint included in a sprayer rental?
No. You supply the coating, and usually the tip, the filters and any solvent for flushing. Some counters bundle a starter kit with a gun filter and a tip guard, which is worth asking about since those are the parts people lose.
How long does cleaning an airless sprayer take?
Budget twenty to thirty minutes at the end of the job. Flush the system with water for latex or the correct solvent for oil-based coatings, clean the gun and pump filters, then run storage fluid through it before it goes back.