An indoor lift rental is an electric machine on non marking tires, quiet enough to work beside occupied space and clean enough to run over a finished floor. Three families cover almost everything: a push around vertical mast from about $90 a day, a slab scissor, and a narrow electric boom up to $250. The building chooses.
Push around mast, slab scissor, narrow boom
A vertical mast lift carries one person and light tools to about twenty five feet in a footprint smaller than a pallet. A slab scissor carries two people plus material. A narrow electric boom reaches over racking, seating and machinery, and it is the only one of the three that gets around an obstacle.
The route in matters more than the height
Measure the tightest doorway, the elevator car if the machine has to go up, the turning space at each corner and the load rating of every floor on the way. Machines are specified by stowed width and height for exactly this reason, and a counter will match one to the numbers you give it.
Non marking tires and what they do not fix
Non marking tires keep black streaks off the floor and do nothing at all about point loading, dropped tools or hydraulic drips. Lay protection where the machine will stand, ask whether the unit has been checked for leaks, and agree with the building who inspects the floor when the hire ends.
Batteries, sockets and working hours
Every one of these runs on batteries, and a full working day flattens them. Find a socket near the parking spot and confirm the charger travels with the machine. In an occupied building ask about permitted hours too, because even an electric lift beeps steadily whenever it travels.
Questions people ask about indoor lift rental
Can I take a normal scissor lift inside?
Only the electric slab models. A rough terrain scissor on lugged tires is heavier, wider, marks the floor and often runs on diesel, so it stays outdoors. Say the work is indoors when you book and let the counter send the machine built for it.
What about working over a suspended floor?
Get the weight and wheel loads from the yard and pass them to the building or its engineer before delivery. Spreader plates or plywood are the usual answer where the numbers are marginal, and they need to be on site before the machine arrives rather than after.
Is a harness required?
In a boom type lift, yes, a harness and lanyard clipped to the anchor in the platform. In a scissor or a vertical mast the guardrails are the primary protection and requirements vary, so check the machine's manual and the site policy before the first lift of the day.